Back to Blog
CMMC & Compliance

CMMC Flow-Down: What a Prime Will Still Ask Its CUI Subcontractors For

CMMC flow-down requirements follow the information a subcontractor handles. Under 32 CFR 170.23, a sub handling only FCI needs Level 1 (Self), and one handling CUI needs at least Level 2 (Self).

Five-axis milling machine cutting a titanium aerospace bulkhead in a defense machine shop

A supplier packet from a prime usually carries a CMMC paragraph, and the paragraph rarely says what you are being asked to prove. CMMC flow down requirements are the answer, and they are narrower than most packets make them sound. Short version: the data decides. Readiness help with CMMC flow down requirements is part of our compliance work.

The pause didn’t repeal any of it. CMMC Phase II, the next step on the rollout, was suspended in July 2026, according to the SBA’s release, but flow-down lives in a regulation and in contract clauses that never waited on a phase.

We covered the suspension itself in what CMMC still requires after November 10. Here the question is narrower. A prime holds a contract with CMMC in it. What lands on you? Still asking whether CMMC reaches you at all? Start with does CMMC apply to my company.

What CMMC Flow Down Requirements Cover

Flow-down is how a prime contractor’s obligations travel to its suppliers. Under 32 CFR 170.23, the prime has to require each subcontractor to hold a CMMC status that fits what that subcontractor will process, store, or transmit in the work: Federal Contract Information, or Controlled Unclassified Information.

Federal Contract Information (FCI) is information the government provides or generates under a contract and doesn’t intend for public release, while Controlled Unclassified Information (CUI) is information that law, regulation or government-wide policy says needs safeguarding, as the National Archives’ CUI program page puts it. Two bins. Two different floors.

Section 170.23(a)(2), the CUI rule: “a CMMC Status of Level 2 (Self) is the minimum requirement for the subcontractor.” Source: U.S. Department of Defense, 32 CFR 170.23, as read November 19, 2026

Four rows cover the whole rule.

Your subcontract involvesMinimum CMMC status for youRule
FCI onlyLevel 1 (Self)170.23(a)(1)
CUI, prime contract asks for Level 2 (Self)Level 2 (Self)170.23(a)(2)
CUI, prime contract asks for Level 2 (C3PAO)Level 2 (C3PAO)170.23(a)(3)
CUI, prime contract asks for Level 3 (DIBCAC)Level 2 (C3PAO)170.23(a)(4)

Look at the last row. A sub handling CUI under a prime whose own contract calls for Level 3 is held to Level 2 (C3PAO), not Level 3. Level 3 isn’t inherited.

A C3PAO assessment means an outside certified third-party assessment organization does the assessing. Nothing in the four rows turns on your headcount, your revenue or your address.

Two details are easy to miss. The rows attach to a subcontract, not to a company, so the same shop can sit in row one for one purchase order and row two for the next. And paragraph (b) of the same section adds that, as with any solicitation or contract, DoD may give specific guidance on flow-down, which means the solicitation’s own words can say more than the table does.

Gloved hands sliding a removable hard-drive caddy into a ruggedized rack-mount unit inside a steel mesh cage

What a Prime Will Still Ask Before Award

The paper that suspended Phase II kept the clause text alive. Class deviation 2026-O0025, Revision 3 still lets contracting offices write CMMC Level 1 (Self) or Level 2 (Self) into procurements. When a contract carries the CMMC clause, DFARS 252.204-7021, its paragraph (f) gives the prime two jobs aimed straight at you: pass the clause down, and check your status before awarding the subcontract. Paragraph (d)(4) adds a third, an annual affirmation.

Translated into what shows up in your inbox:

  • Proof of a current CMMC status at the level your subcontract calls for. The clause says “prior to awarding,” so the ask comes before the award, not after.
  • An affirmation from your affirming official, the person who can attest that you continue to meet the requirements. One before award, then one every year, and paragraph (d)(4) words it per system, for each of yours that will handle FCI or CUI on the work. The SPRS score and annual affirmation post walks through the mechanics.
  • The same clauses, untouched. DFARS 252.204-7012(m) has the prime include its clause in subcontracts “without alteration, except to identify the parties,” commercial products and services included.
  • A promise about incidents. When you report a cyber incident to DoD, you give the prime (or your next higher-tier subcontractor) the incident report number DoD assigns, as soon as practicable. Asking the contracting officer to vary from a NIST SP 800-171 requirement? Tell the prime too.
  • Where does this stop? 170.23 applies “throughout the supply chain at all tiers,” so if you hand FCI or CUI to your own suppliers, expect to carry the same logic one tier down.

Why does the prime ask at all? Because paragraph (f) makes the check the prime’s job, which turns the packet question into a prime doing what its own contract tells it to do, whatever tone the purchasing contact’s email happens to take. The clause says so.

FCI-only subs get a shorter list. FAR 52.204-21, the basic safeguarding clause, flows down in paragraph (c) to subcontracts where the sub may have FCI, and its safeguards number 15. Read the text on acquisition.gov.

Working Out Whether Your Subcontract Touches CUI

This is where most of the confusion starts, because the prime owns the call. DFARS 252.204-7012(m)(1) has the prime decide whether information given to a subcontractor “retains its identity as covered defense information,” consulting the contracting officer if necessary. You can read the clause on acquisition.gov. You can’t make that determination for the prime.

You can make it visible. Three steps, in this order:

  1. Ask in writing. Will any FCI or CUI reach our systems under this subcontract? Which clause list governs?
  2. Put the answer against the table above. If it’s CUI, ask which CMMC level the prime contract itself calls for, because that one answer separates row two from rows three and four.
  3. Write down every system the information would sit on, from the shared drive to one engineering workstation, since that list is what any later assessment has to cover.

Fair warning: the next paragraph is clause numbers and little else. The CMMC clause’s flow-down paragraph excludes “commercially available off-the-shelf items.” So does the DoD assessment clause, DFARS 252.240-7997(g). DFARS 252.204-7012(m) names commercial products and services and, in the text we read, has no off-the-shelf exception of its own.

Which side of that line a given part falls on is a question for the prime or the contracting officer, in writing, not a guess from a clause number. Ask first.

Smooth pale grey radome on a steel test stand in an antenna test hall lined with foam cones

A Short List to Settle Before the Packet Arrives

  • Name your affirming official now. One person, with the authority to sign.
  • Pull up your SPRS entries and read them as a stranger would.
  • Line up the clause lists from your last few purchase orders. Mark every number you haven’t seen before.
  • Which of your own suppliers would touch this information? If none, say so on paper.
  • Treat an acknowledgment line in a packet as a statement about your systems. Don’t sign one you can’t map to a table row.

Plenty of companies work through this list alone, and that is fine. Start there. If you’d rather have someone walk the table with you, the cluster gives CMMC readiness guidance and refers companies to third-party assessors, and we don’t certify anyone. Formal CMMC certification requires a third-party assessment organization.

Our CMMC guides for small suppliers cover the surrounding steps, and prime contractor matchmaking is a separate service that facilitates introductions to defense prime contractors. It doesn’t promise one.

One cost note belongs here. Third-party CMMC assessments involve fees charged directly by the assessors, not by the cluster, and if a referral involves outside fees, your point of contact tells you before anything moves forward.

Before You Sign the Flow-Down Terms

Does my prime’s CMMC level automatically become mine?

Not automatically. Section 170.23 ties your minimum to what you will handle, so an FCI-only sub is at Level 1 (Self) whatever the prime holds. The exception sits in the table: a CUI sub under a prime contract that calls for Level 2 (C3PAO) or Level 3 (DIBCAC) is held to Level 2 (C3PAO).

How do you tell whether a subcontract carries CUI?

CUI is information the government says needs safeguarding, and under DFARS 252.204-7012(m)(1) the prime decides whether yours qualifies. Ask in writing. A one-line answer from the prime beats a guess based on a drawing’s look.

Can a prime ask for more than the rule requires?

The rule sets minimums. Section 170.23 says so in plain words, and what a particular purchase order adds on top is written in that purchase order. Read its terms, ask the prime which clause drives each request, and take a legal question about the language to counsel.

Does buying off-the-shelf parts change any of this?

The CMMC clause’s flow-down paragraph leaves out commercially available off-the-shelf items, and so does DFARS 252.240-7997, but DFARS 252.204-7012(m) is worded differently, so the safe move is a written question to the prime. Name the part and the information that travels with it.

What happens to the incident report if you sit three tiers down?

72 hours. That is the window DFARS 252.204-7012 gives to report a cyber incident to DoD at DIBNet. The incident report number DoD assigns then goes up the chain, to your higher-tier subcontractor first, until it reaches the prime.

Will the cluster sign off on a supplier packet?

That isn’t a service we offer. We give readiness guidance and referrals, and we explain how a clause list maps to a table row. The packet, and whatever status it asks for, stays between you and the prime.

Get Ready Before the Packet Lands

The SoCal Defense Innovation Cluster provides CMMC readiness guidance and referrals to certified assessors for eligible small businesses in Orange, Los Angeles, and San Diego Counties. Membership and cluster-funded services are provided at no cost to eligible participating businesses, subject to program requirements and available resources.

Apply for Free Membership